Tuesday, April 10, 2018

Carrige rebuild

The Carrige is mounted and slides on the Selector mech (Pinbank).
I dont have a clear picure of how the Carrige itself works with the Selector but it will definitely need to be cleaned.

Carrige with the Carrier plate



Dirt in all connectors



Finished and ready for installation

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Got the BADGE !!!!

Finely after three years searching everywhere for the grille Badge, I saw on facebook marketplace that  Michael  R in US parted out an RO 1...

  • Selector cleaning
    This was a PITA to do, as the springs loaded 30 pin's on the four sectors was almost impossible to get in place and fit intothe corresp...
  • Recapping and rebuilding the Rockola amplifier 31451-A
    As I bought a quite fresh amp I dont need to do anything on the outside except a little cleaning. I decided to replace all caps and resis...
  • Magazine motor & Gripper motor
    Magazine motor before cleaning and checking This motor have been refurbished, the grease was soft and the cable is in good shape also...