Magazine motor before cleaning and checking
This motor have been refurbished, the grease was soft and the cable is in good shape also. Just added new grease and brushed the outside.
Gripper motor was compleatly stuck and my heat gun was needed once again to thaw the grease in the gearbox.
I had to open the motor and cut away the hard grease with a knife.
Inside near the brushes the cables insulation was falling apart so a new cable is a must here!
Except for the dirt and bad leaders the gripper motor looked ok inside.
New fresh grease was also added
What is trick for removing tje mack cover. It is locked to armature with a C clip that is impossib le to get to?
ReplyDeleteCorrection: What is the trick to removing the back cover? It is locked to the armature with a c clip that is impossible to get to?
ReplyDeleteThe trick is to loosen the screws holding the motor cover and then turn the motor shaft backwards with the shaft sticking out of the back of the motor cover. At the same time pull gently the commutator/cover out from the gearbox.
ReplyDeleteThanks
ReplyDeleteHow did you remove the motor shaft from the magazine motor? I removed the back cover but the shaft would not pull out. Thanks for any help
ReplyDeleteSame here!
Delete